just a suggestion really i am trying to take a rollcage out and on one side it was bolted right throough both seals and on the other i cannot find the atchuall nut i found the bolt head but cannot untighten the bloody thing!!! any suggestions??? well that is befor i cut the seal off to see in they bolted it on inbetween the two!!!
thanks Andy p
can u grind the head off the bolt?..
It may have had a cover seal fitted after the cage was put in so it might be covering the bolt.
Like paul says.. grind the head off the bolt. Beats cutting the floor about
only catch is you may have a small rattle from that corner
> only catch is you may have a small rattle from that corner
its a mini… who’d notice
true although i aint drove mine in 9 months so im forgetting all them clunks and rattles
i know that feeling as i have not driven mine in over 6months!!! also the bolt in hand is located in the inner bin and i only have a 9inch cutting disc so could have a little problem with that!!! was thinking just cutting a small section out of the bottom and rewelding a new plate on after i am done!!!unless anyone is near milton keynes that can leand me a smaller cutting instrument
